Super Systems 3L Series - Manual (Page 28)

Operations Manual Series 3L
28
7.2 Output Channel 3 (OP-3) – Series 3L Indicators
Output 3 is always a form A relay in the indicator and is connected to terminals 3A and 3B. It is typically used to
provide external indication of alarms.
Output 3 is configured using the parameters in the following table:-
OUTPUT LIST 3 ‘o p -3 ’
Name Scrolling Display Parameter
Description
Value Default Access
Level
3.I D I/O 3 TYPE Displays the type of
output ReLy Relay output ReLy Read
only
3.FUNC I/O 3 FUNCTION The function may be
turned off, otherwise
set to
d.out
none Disabled. If disabled no further
parameters are shown none Conf
d.out Digital output
3.SRC.A I/O 3 SOURCE A Selects the source of
an event which will
operate the output
relay
The output status is
the result of an OR of
Src A, Src B, Src C,
and Src D
Up to four events can,
therefore, operate the
output
See section 7.2.2.
none No event connected to the
output
none Conf
3.SRC.B I/O 3 SOURCE B 1.--- Alarm 1 The --- indicates the
alarm type. If the
alarm is not
configured
AL.(Alarm no) is
shown
2.--- Alarm 2
3.SRC.C I/O 3 SOURCE C 3.--- Alarm 3
4.--- Alarm4
3.SRC.D I/O 3 SOURCE D ALL.A All alarms. Logical AND of
alarms 1 to 4.
nw.AL Any new alarm
Pwr.f Power fail.
O.rng Output relay operates if the
indicator input is over range
sbr Sensor break alarm
3.SENS I/O 3 SENSE To configure the
sense of the output
channel.
See also section 7.2.1 nor
Inv Normal
Inverted nor Conf