Super Systems 3L Series - Manual (Page 18)

Operations Manual Series 3L
18
5. Access to Further Parameters
Parameters are available under different levels of
security and are defined as Level 1 (Lev1), Level 2
(Lev2), Level 3 (Lev 3) and Configuration (Conf).
Level 1 has no pass code since it contains a minimal
set of parameters generally sufficient to run the
process on a daily basis. Level 2 allows access to
parameters which may used in commissioning an
indicator or settings between different products or
batches. This has been described in the previous
section.
Level 3 and Configuration level parameters are also
available as follows:
5.1 Level 3
Level 3 makes all operating parameters available and
alterable (if not read only). It is typically used when
commissioning an indicator.
Examples are:
Range limits, setting alarm levels, communications
address.
5.2 Configuration Level
This level makes available all parameters including the
operation parameters so that there is no need to switch
between configuration and operation levels during
commissioning. It is designed for those who may wish
to change the fundamental characteristics of the
instrument to match the process.
Examples are:
Input (thermocouple type); Alarm type;
Communications type.
WARNING
Configuration level gives access to a wide range of
parameters which match the indicator to the
process. Incorrect configuration could result in
damage to the process and/or personal injury. It is
the responsibility of the person commissioning the
process to ensure that the configuration is correct.
In configuration level, the indicator is not providing
alarm indication.
Do not select configuration level on a live process.
Operating
Level Home
List Full
Operator Configuration Alarms
Level 1  Yes RW
Level 2  Yes RO
Level 3   Yes
Conf    No