Super Systems 3L Series - Manual (Page 37)

Series 3L Indicators
37
9.4 Diagnostic Alarms
Diagnostic alarms indicate a possible fault within the indicator or connected devices.
Display shows What it means What to do about it
E.Conf A change made to a parameter takes a finite time
to be entered. If the power to the indicator is
turned off before the change has been entered
then this alarm will occur.
Do not turn the power off to the indicator while
ConF is flashing
Enter configuration mode then return to the
required operating mode. It may be necessary to
re-enter the parameter change since it will not have
been entered in the previous configuration.
E.CaL Calibration error Re-instate Factory calibration
E2.Er EEPROM error Return to factory for repair
EE.Er Non-vol memory error Note the error and contact your supplier
E.Lin Invalid input type. This refers to custom
linearisation which may not have been applied
correctly or may have been corrupted. Go to the INPUT list in configuration level and set a
valid thermocouple or input type