Super Systems 3L Series - Manual (Page 24)

Operations Manual Series 3L
24
DIRECTION Dwn Down scale. Output goes to
minimum
CJC.IN CJC
TEMPERATUR
E Temperature measured at
the rear terminal block.
Used in the CJC calculation
(only shown for
thermocouple inputs) Read only Conf
L3 R/O
and if T/C
PV.IN PV INPUT
VALUE Current measured
temperature Minimum display to maximum display range Conf
L3 R/O
MV.IN MILLIVOLT
INPUT VALUE Millivolts measured at the
rear PV Input terminals xx.xx mV - read only
P.RST PEAK RESET Select ON to reset the HIGH
and LOW peak values. The
display automatically returns
to OFF
OFF peak
Values
reset OFF
On
LOW PEAK LOW This is the lowest reading
that the indicator has
recorded since switch on or
since it was reset Read only L1
HIGH PEAK HIGH This is the highest reading
that the indicator has
recorded since switch on or
since it was reset Read only
L1
6.1.1 Input Types and Ranges
Input Type Min
Range
Max
Range
Unit
s
Min
Range
Max
Range
Unit
s
J.tc Thermocouple type J -210 1200 o C -238 2192 o F
k.tc Thermocouple type K -200 1372 o C -238 2498 o F
L.tc Thermocouple type L -200 900 o C -238 1652 o F
r.tc Thermocouple type R -50 1700 o C -58 3124 o F
b.tc Thermocouple type B 0 1820 o C -32 3308 o F
n.tc Thermocouple type N -200 1300 o C -238 2372 o F
t.tc Thermocouple type T -200 400 o C -238 752 o F
S.tc Thermocouple type S -50 1768 o C -58 3214 o F
rtd Pt100 resistance thermometer -200 850 o C -238 1562 o F
mv mV or mA linear input -10.00 80.00
Cms Value received over digital communications (modbus address 203).
This value must be updated every 5 seconds or the indicator will show sensor break
6.1.2 Units
O C o C O F o F O k Kelvin
none No units displayed Perc Percentage