Super Systems 3L Series - Manual (Page 19)

Series 3L Indicators
19
5.2.1 To Select Access Level 3 or Configuration Level
Do This The Display You Should See Additional Notes
1. From any display press and
hold

for more than 5
seconds
To Select Level 3
The display will pass from the current operating
level, for example,
Lev 1 to Lev 3 as the button
is held down.
(If no button is then pressed for about 50 seconds
the display returns to the HOME display)
2. Press

or

to enter the
passcode for Level 3
The default code is 3:
If an incorrect code is entered the display reverts to
‘g o t o ’.
If a correct code is entered the indicator is now in the
level 3 will then revert to the HOME display
3. When the
LEV3 GOTO view is
shown, as in paragraph 1
above, press

to select
‘
Conf’
To Select Configuration
level
Note:

must be pressed quickly before the
indicator requests the code for level 3
4. Press

or

to enter the
passcode for Configuration
level
The default code is 4:
If an incorrect code is entered the display reverts to
‘g o t o ’.
If a correct code is entered the indicator is now in
Configuration level will now show
Conf
5. Press and hold

for more
than 3 seconds
6. Press

to select the
required level—for example,
LEV 1
To Return to a Lower Level
The choices are:
LEv 1 Level 1
LEv 2 Level 2
LEv 3 Level 3
ConF Configuration
It is not necessary to enter a code when going from
a higher level to a lower level.
Alternatively, press

and scroll to the A c c e s list
header, then press to select the required level.
The display will then flash ‘ ConF’ for a few seconds
and the indicator will then go through its start up
sequence, starting in the level selected.
Do not power down while
Conf is flashing. If a
power down does occur an error message will
appear – see section 9.4 ‘Diagnostic Alarms’

A special case exists if a security code has been
configured as ‘0’ If this has been done it is not
necessary to enter a code and the indicator will enter
the chosen level immediately.

When the indicator is in configuration level the
ACCESS list header can be selected from any view by
holding down the

button for more than 3 seconds.
Then press

again to select ‘ ACCES’
3
code
Lev 3
goto
0
code
Conf
goto
0
code
Conf
4
code
Conf
goto
Lev1
goto