Super Systems 3L Series - Manual (Page 22)

Operations Manual Series 3L
22
5.5 Access Parameters
The following table summarizes the parameters available under the ACCESS list header
!
The Access List can be selected at any time when in configuration level by holding

key down for 3
seconds, then press

or

with

still held down. Use the button to scroll through the menu options.
ACCESS LIST ‘ A C C S ’
Name Scrolling
Display Parameter Description Values Allowed Default Access
Level
G O T O GOTO Allows you to change the access level
of the indicator. Passwords prevent
unauthorized change Lev.1 Operator level 1 Le
v.
1
Conf
Lev.2 Operator level 2
Lev.3 Operator level 3
Conf Configuration level
LEV2.P LEVEL 2
PASSCODE The Level 2 passcode 0-9999
0 = no passcode will be requested
2 Conf
LEV3.P LEVEL 3
PASSCODE The Level 3 passcode 3 Conf
CONF.P CONFIG
PASSCODE To set a Configuration level passcode 4 Conf
I D CUSTOMER
ID To set the identification of the indicator 0-9999 Conf
H O M E HOME
DISPLAY See
Note 1 To configure the parameters to be
displayed in the HOME display pV Process Value – top display
Blank lower display St
d
Conf
aLm First configured alarm – top
Blank lower display
pV.aL PV - top display
First configured alarm in lower
section
p.a.ro PV - top display
First configured alarm read
only in lower section
K . L O C K KEYBOARD
LOCK
To limit operation of the front panel
buttons when in operator levels.

If ALL has been selected, then to
restore access to the keyboard, cycle
power to High Limit with the

button held down and enter the
configuration level passcode as
described in section 3.1.1. This will
take you to the Quick Code mode.
Press to scroll to the EXIT option
and select YES. The front panel
buttons can then be operated as
normal.
none Unlocked none Conf
ALL All buttons locked
Edit Edit keys locked
C O L D COLD START
ENABLE/
DISABLE Use this parameter with care.
When set to yes the indicator will
return to factory settings on the next
power up
No Disable Conf
YES Enable
P A S S . C FEATURE
PASSCODE
To enable chargeable options Conf
M E S G STATIC HOME
MESSAGE Up to 15 messages can be configured.
This parameter calls up messages 1 to
15. OFF The HOME display is
configured according to the
parameter HOME above Off Conf
1 to Message 1
15 Message 15
The following sections in this handbook describe the parameters associated with each subject. The general format of
these sections is a description of the subject, followed by the table of all parameters to be found in the list, followed by
an example of how to configure or set up parameters.