SoundTraxx Tsunami Steam Technical Reference - Manual (Page 45)

Tsunami Technical Reference Page 43
CV 49-52
Hyperlight Effect Select
Description
Used to set the Hyperlight lighting effect and control mode for their respective
output:
CV 49, Headlight Effect Select
CV 50, Backup Light Effect Select
CV 51, FX5 Effect Select
CV 52, FX6 Effect Select
Bits 0-3: EF[0..3] Effect Type Select
0 = On/Off output
1 = Rule 17 Dimmable headlight
2 = Mars Light
3 = Pyle Gyralite
4 = Oscillating Headlight
5 = Single Flash Strobe
6 = Double Flash Strobe
7 = Western Cullen D312 Rotary Beacon
8 = Prime Stratolite
9 = Type I Ditch Light
10 = Type II Ditch Light
11 = FRED (End of Train flasher)
12 = Engine Exhaust Flicker
13 = Firebox Flicker
14 = Smart Firebox Flicker
15 = Dyno-Light
Most of the effects are self-descriptive. However a few need some
additional notes:
Dimmable Headlight - The function output is normally an on/off output.
If the output is on, the output level will be reduced about 60% whenever
the dimmer function is on.
Type I and Type II Ditch Lights - These are identical when operating.
However, if the grade crossing logic is enabled, the Type I ditch light will
revert to a steady on state when it is not flashing whereas the Type II
lights will turn off.
Lighting Effect CVs
Bit 7 Bit 0
LED R17 XING PHSE EF3 EF2 EF1 EF0