SoundTraxx Tsunami Steam Users Guide - Manual (Page 73)

Tsunami Steam Sound User’s Guide Page 70
Troubleshooting
temperature has fallen back to a safe level. An Over-temperature fault is
usually due to inadequate ventilation or using a motor load that exceeds
the decoder’s rating.
Error 10 - Over voltage fault
An Over-voltage fault indicates that the track voltage is greater than 22
volts. When this error occurs, motor control and sound will be shut off
and the error code will continue to flash until the voltage is brought below
22 Volts. Note: Tsunami’s absolute maximum voltage input is 27 volts!
Track voltages exceeding 27 volts may cause permanent damage to the
decoder.
Error 11 - Motor Connection Fault
This error indicates a faulty motor connection has been detected and
typically occurs when the motor lead is shorted to a track pickup wire.
The motor will not respond until the error is corrected.
Error 12 - Motor Overload Fault
This error indicates the motor load has exceeded the decoder’s current
rating. Supported on Models TSU-4000 and TSU-8000 only.
Error 16 - CVS reset to default
This code is informational only and indicates that all CVs have been reset
to their factory defaults.
On rare occasion, the Tsunami Decoder may also report the following error
codes which cannot be remedied by the user and require a return to the
factory for repair:
Error 1 - COP Fault
Error 2 - Software Fault
Error 5 - EEROM Checksum failure
Error 6 - Lower Calibration Voltage Error
Error 7 - Upper Calibration Voltage Error
If you are still having difficulties, contact our customer service department for
guidance.
SoundTraxx Service Department
210 Rock Point Drive
Durango, CO 81301
Telephone (970) 259-0690
Fax (970) 259-0691
Email: [email protected]