Basic programming – SoundTraxx Tsunami Steam Users Guide User Manual
Page 36
Tsunami Steam Sound User’s Guide
Page 33
Example 2, LED Firebox Flicker
In this example, we will configure the FX5 and FX6 outputs for a firebox
flicker effect using LEDs.
1. We first look up the initial CV value in Table G for a Firebox Flicker under
the column labeled ‘Crossing Logic Off’ and find it is 13 for Phase A and
29 for Phase B. Since we are setting up two lights, the overall effect will
be enhanced if one LED flickers differently from the other. So for FX5 we
use the Phase A value, 13, and for FX6 we use the Phase B value, 29.
2. Since we are not using Rule 17, we skip to Step 3.
3. Since we are using LEDs, we add 128 to the values found in Step 1 and
get:
FX5 = 13 + 128 = 141
FX6 = 29 + 128 = 157
4. CV 51 (FX5 configuration) is programmed with the value found in Step 3
or 141. CV 52 (FX6 configuration) is likewise programmed with 157.
On-off
Dimmable
Mars Light
Gyralite
Oscillating Headlight
Single Flash Strobe
Double Flash Strobe
D312 Rotary Beacon
Prime Stratolite
Type I Ditch Light
Type II Ditch Light
FRED
Exhaust Flicker
Firebox Flicker
Smart Firebox Flicker
Dyno-Light
Effect Type
Phase A Phase B
CV Value
Crossing Logic Off Crossing Logic On
Phase A
Phase B
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
Table G. Hyperlight Control Mode Settings
Basic Programming