Sloan EW-72000 Installaton - Manual (Page 6)

10 Connect Power Cable to
Transformer and Plug Transformer
into Receptacle
A
Connect Spade Terminals
on Power Cord to the
Transformer.
B
Drop Braided Hose Supply Line through service access hole.
C
Connect Braided Hose Supply Line to right side of Shut Off
Valve in Head.
Note: To ease Supply Line installation, remove the two screws
holding the Shut Off Valve Bracket. After connecting Supply Line,
reinstall the Shut Off Valve Bracket.
A
Drop Power Cord through service access hole.
8 Connect Supply Line to Shut Off
Valve in Head
SERVICE ACCESS
HOLE BRAIDED HOSE
SUPPLY LINE SHUT OFF
VALVE
9 Connect Supply Line to
Thermostatic Mixing Valve
A
Install water line.
6
B
Plug Transformer into
outlet.
11 Open Shut Off Valve, Turn on Water
Supply, Check for Water Leaks and
Install End Caps
A
Open Shut Off Valve and turn on water supply.
END CAP
C
Replace End Caps. Insert the screw located on the inside of the
Cap into the enlarged hole of the Frame. Then slide the Cap into
place. Loosely install the two front screws. Slide End Cap UP to
eliminate any gap between the End Cap and Basin. Tighten the
inside screw securely. Lastly, tighten the two front screws
securely. Follow the same procedure for the second End Cap.
B
Check all plumbing for water leaks.
Double Station Sink Shown
SHUT OFF VALVE
BRACKET
Shut Off
Valve