Seaward PAT2000i - Manual (Page 16)

a selection has been made and it should action the request. NOTE: no action will follow
unless the hash (enter) key has been pressed.
PROCEDURE
STEP 1
Connect the PAT2000i to the mains supply. On power up the unit will display:
SEAWARD TESTER
PAT2000i
Then the memory is tested, if all ok message ‘PASS DATA CHECKSUM’ is displayed.
On power up the PAT2000i may display:
VOLTS ON NEUTRAL
PRESS # ONLY IF SAFE
ONLY proceed if the reasons are known.
The unit will then prompt:
IS THIS RIGHT Y/N
16 MAR 95 (16:03:95)
If the date is correct press the Y key and the program will sequence to the next
instruction. If the date is not correct press the N key and the instrument will then lead
the operator through a sequence of setting the day, month and year. At the end of this
sequence the new date will be displayed and the user asked to confirm whether it is
correct or not. (Should the user make an error during the set up procedure of the date
he will now have the opportunity to correct this.)
DIRECT USER CONTROL MODE.
At the prompt PRESS # FOR NEW TEST, press the D on the keypad. The following
message will appear; DIRECT USER CONTROL! TESTS ARE NOT LOGGED
followed by the following screen;
1 =A1 2A;2=A230V;3=ETH
4=lNS;5=FL;6=LD;7=CNT
Pressing 1 will change the earth current
Pressing 2 will toggle between 230V and 110V test sockets
Pressing 3 will perform an earth test at the current selected by 1
Pressing 4 will perform an insulation test
Pressing 5 will perform a flash test
Pressing 6 will perform a load and leakage test
Pressing 7 will perform a continuity test on an IEC lead
LEGISLATION SELECT
At the prompt PRESS # FOR NEW TEST, press the L on the keypad.
Pressing N key will cyclically prompt two options:
IN SERVICE TEST? Y/N
‘AS NEW‘ TEST? Y/N
Pressing the Y key will select the displayed option.
NOTE: The selected option will be remembered only whilst the unit is powered. At
power up the PAT2000i defaults to the “IN SERVICE” test thresholds for
PAT 2000i Portable Appliance Tester
13
PAT 2000i Booklet 7/3/03 4:26 pm Page 14