RJS Inspector D4000 Auto Optic (FIRMWARE version A.05 and Earlier) - Manual (Page 55)

Operator
’
s Guide Appendix G
002-5564 RJS, Minneapolis, MN 48
Appendix G (Symbology Analysis)
Symbology Analysis Parameters
Table G-1 shows error messages that will be displayed for each parameter type checked by
the Inspector 4000.
Table G-1 (Parameter/Error Message)
Parameter Data Analysis Message
Ratio Warning Ratio
Inter-Character Gap (ICG) Invalid Format
Valid Data Character Invalid format
Mod Check Digits Bad Mod Check
PCS Warning PCS
Bar Width Deviation Range Warning Wide (or narrow)
Bar Width Deviation Ave. Rejected Wide (or narrow)
Addendum Parity
(UPC/EAN) Invalid Format
ANSI Decodability
(if enabled) Warn D/bility (DCD, in initial
Pass/Fail screen)
Object in Quiet Zone Defects F, 50% or greater typ.