Communication software guideline – RGBLink VSP 3500 User Manual User Manual
Page 61
5. Communication Software Guideline
Run Software
VSP 3500 User Manual 61
PC software, concreteness can refer to:
“How to control processor with
Note
RS 232 Serial line, all USB line can upgrade
procedures.
After USB connection or serial connection, click to search equipment, the
equipment search and connect automatically. If you use network,
equipment IP address by default is: 192.168.0.100, please set the IP
address of the computer firstly, set up the computer in the same network
segment, different IP address, you can communicate, such as:
192.168.0.99.
In addition, VSP 3500 PC software can also control many set of
equipment, if the user need more table control, you can click to add,
appear interface as follows:
Input equipment name, if you choose a serial port or USB communication,
need to choose communication COM port and baud rate, if you choose
network communication, you need to set equipment IP address, the local
port and remote port is 1000 by default.
If you need to reduce the connected device, click delete or delete all to
clear.