How to realize led screen connection – RGBLink New Driver 2 Quick Start User Manual

Page 9

Address：S602-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

card to LED screen, connecting the both Port D and Port U of one sending card to LED screen,

connecting the Port D and Port U of two sending cards to LED screen. The following are the detailed

operation steps of the three connection.

1. Connect the Port D or Port U of One Sending Card to LED Screen

Here we take No.1 sending card, port U1 for example. (Note: No.1 sending card

corresponding to port D1 and port U1, No.2 sending card corresponding to port D2 and

port U2.

(1) First, make sure that the device is in normal operation. The red power indicator lights when

the device has power supply and the green signal indicator lights when device has signal input.

(2) Choose the input source, for example, DVI.

(3) Connect the cable to Port U1.

(4) Turn the knob, choose [SENDING CARD TYPE], push the knob to confirm, turn the

knob, choose the sending card model, for example, Linsn (New Driver 2 can only

support Linsn and Colorlight sending card). Shown as follows:

(5) After setting, turn the knob, choose [QUICK POINT SCREEN], push the knob to

confirm for next setting, shown as follows:

*SENDING CARD TYPE LINSN

BRIGHTNESS SET >>

QUICK POINT SCREEN >>

Gamma SET >>

>SENDING CARD TYPE NOVA STAR

BRIGHTNESS SET >>

QUICK POINT SCREEN >>

Gamma SET >>