RGBLink New Driver 2 Quick Start User Manual
Page 12
Address：S602-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
11
Send to receiver after choose the connection mode, observe the display screen and make sure if
display image is correct. If wrong, change the connection modes. Then connect the Port D or Port U of
One Sending Card to LED Screen is finished.
(9) The setting for port D1 is same as the above setting.
Rendering is as follows:
2. Connect the Port D and Port U of One Sending Card to LED Screen
(1) First, make sure the device is in normal operation. The red power indicator lights when
device has power supply and the green signal indicator lights when device has signal
input.
(2) Choose the input source, for example, DVI.
(3) Connect one cable to Port D1, the other one to U1.
(4) Connect Port U1 of No.1 Sending Card to LED screen, the settings are same as Step 4
to Step 8 of “Connect the Port D or Port U of One Sending Card to LED Screen”.
(5) Connect Port D1 of No.1 Sending Card to LED screen, setting steps are as follows:
a. Turn the knob, choose [SENDING CARD TYPE], push the knob to confirm, turn the
knob, choose the sending card model, for example, Linsn (New Driver 2 can only
support Linsn and Colorlight sending card, Nova sending card can only do brightness
adjustment). Shown as follows: