RGBLink New Driver 2 Quick Start - Manual (Page 23)

Address：S602-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
22
4. Connect the power line of sending card, (connect to the position marked LINSN POW of the MCU
board), take a 4 pin 2.54 mm pitch cable, and connect referring to the following figure:
5. Connect the serial line of the sending card to the MCU board ( the position marked with LINSN UART
of MCU control board), as shown below:
6. Connect the signal and power indicator light cable of sending card, take each 2 red and black lines,
and connect 2 black lines to the end of MCU board (right of sending card), and connect 2 red lines near
the edge of the MCU board (left of sending card). Please refer to the following figure: