RGBLink New Driver 2 Quick Start User Manual

Page 14

Address：S602-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

e. Turn the knob, and choose [RECEIVING CARD SET], push the knob to confirm. Turn

the knob, set D to U offset Y as 240 (Note: D to U offset Y=HORIZONTAL

CARD×HEIGHT, before we set horizontal card as 2 and height as 120). Shown as

follows:

f. Turn the knob, and choose [CONNECT CARD TYPE] , shown as follows:

Choose the connection mode, the setting is same as Port U1. Then connection of both the Port D and

Port U of One Sending Card to LED Screen is finished.

Rendering is as follows:

SENDING CARD NO.1

>CHOOSE NETWORK PORT U

SENDING CARD SET >>

RECEIVING CARD SET >>

SENDING CARD NO.1

CHOOSE NETWORK PORT U

SENDING CARD

SET >> >RECEIVING

CARD SET >>

CHOOSE NETWORK PORT U

D TO U OFFSET X 0

D TO U OFFSET Y 240

CONNECT CARD TYPE >>

CHOOSE NETWORK PORT U

D TO U OFFSET X 0

D TO U OFFSET Y 0

CONNECT CARD TYPE >>