RGBLink New Driver 2 Quick Start - Manual (Page 8)

Address：S602-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
7
How to Connect
Connect the HD player, DVD or computer to the HDMI input interface port using the HDMI cable.
Connect the DVI player or computer to the DVI interface port using the DVI cable.
Connect the computer to the USB control port of sending card using a USB cable.
Connect the receiving card of LED Display to the Gigabit Copper Port with CAT 5 cable.
Connect the microphone or other devices to an audio interface with 3.5mm headphone cable.
Plug in power cord with IEC connector.
How to Work
Switch ON the power button, then the red indicator will glow to indicate the device is in normal
operation. When the both DVI and HDMI signals are given as inputs to the device, the green signal
indicator lights up. Since the HDMI is the first priority than the DVI signal, so that the output will be the
HDMI signal. When the HDMI signal cable is pulled out, the green signal indicator lights up, then the
device output is the DVI signal.
How to Control the Brightness of Sending Card
1. Turn the knob, and choose [BRIGHTNESS SET], then push the knob to confirm.
2. Turn the knob, choose [SENDING CARD], choose NO.1 or NO. 2, then push the knob to confirm.
3. Turn the knob, and choose [BRIGHTNESS], user can adjust the brightness between the range of
1%~100%.
4. Choose [SAVE BRIGHTNESS] to save the brightness after setting.