RGBLink New Driver User Manual - Manual (Page 47)

New Driver User Manual 47
Linsn Sending Card Panel Installation
1. Lock Linsn sending card by 6 screws P (3*5), as shown in the below red circle, and by
two screws (3*6) with a flat pad screws power ground, as shown in the blue box shown in
the diagram below. Then take a terminal line ( φ 4.0 round head terminal, +5 mm
immersion, 1015-18 #/, yellow green double color line, 170 mm long), weld one end of
the subline to the stand on network interface of sending card:
Note: Lock the sending card with welding line to the left position in the above figure.
2. Set the dial switch of sending card, as shown in the following figure.