How to cascade the device, System setup and operations – RGBLink New Driver User Manual User Manual
Page 35
5. System Setup and Operations
How to Cascade the Device
New Driver User Manual 35
1. Push MENU button of Device 2, rotate the knob, choose [CASCADE], and
choose ON.
2. Connect the computer and Device 1 with USB cable, then connect the
male port of DB9 serial line to the female port of Device 1, and connect
the female port of DB9 serial line to the male port of Device 2.
3. Set cascade dial switch 1 downwards, and set cascade dial switch 2
upwards, then Device 1 and Device 2 cascade is finished.
4. Push MENU button of Device 3, rotate the knob, choose [CASCADE], and
choose ON.
5. Connect the male port of DB9 serial line to the female port of Device 2, and
connect the female port of DB9 serial line to the male port of Device 3.
6. Set cascade dial switch 1 upwards, and set cascade dial switch 2
downwards, then Device 2 and Device 3 cascade is finished.
7. Push MENU button of Device 4, rotate the knob, choose [CASCADE], and
choose ON.
8. Connect the male port of DB9 serial line to the female port of Device 3, and
connect the female port of DB9 serial line to the male port of Device 4.
9. Set cascade dial switch 1 and cascade dial switch 2 downwards, then
Device 3 and Device 4 cascade is finished.
Currently, it can cascade 4 sets of device, it is only available for Linsn
sending card currently.
Note
DB9 serial male port DB9 serial female port