beautypg.com

RGBLink New Driver User Manual User Manual

Page 46

background image

New Driver User Manual 46

follows:

1. Take a piece of sending card, and remove the stand of the LEDs, weld on a 2*2 pin,

2.54 mm pitch row needle, as shown below (applicable to LINSN, Colorlight T7 and Nova

sending card).

2. Take another sending card and a 3P double line (30 cm long, 2.54 pitch), cut one side

of the stand, and weld to the back of sending card, as shown in the figure below:

Note: Step 2 is only applicable for Linsn sending card.

3. After welding, connect the other end of 3P double line to the red box area of MCU

board, as shown in the figure below:

This manual is related to the following products:
See also other documents in the category RGBLink Equipment: