RGBLink New Driver User Manual - Manual (Page 37)

5. System Setup and Operations
How to Realize LED Screen Connection
New Driver User Manual 37
How to Realize LED Screen Connection
New Driver can realize two connection as follows connecting the Port D or Port U of one
sending card to LED screen, connecting the both Port D and Port U of one sending card to
LED screen. The following are the detailed operation steps of the three connection.
1. Connect the Port D or Port U of One Sending Card to LED Screen
(1) First, make sure that the device is in normal operation. The red power indicator lights
when the device has power supply and the green signal indicator lights when device
has signal input.
(2) Choose the input source, for example, DVI.
(3) Connect the cable to Port U.
(4) Turn the knob, choose [SENDING CARD TYPE], push the knob to confirm, turn the
knob, choose the sending card model, for example, Linsn (New Driver can only
support Linsn and Colorlight sending card). Shown as follows:
(5) After setting, turn the knob, choose [QUICK POINT SCREEN], push the knob to
confirm for next setting, shown as follows:
*SENDING CARD TYPE LINSN
BRIGHTNESS >>
QUICK CONNECTION >>
EDID >>
>SENDING CARD TYPE NOVA STAR
BRIGHTNESS >>
QUICK CONNECTION >>
EDID >>