D-Link DIR-412 - Manual (Page 89)

85 D-Link DIR-412 User Manual
Section 5 - Connecting to a Wireless Network
Connect Using WCN 2.0
The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista ® . The following instructions for setting this up
depends on whether you are using Windows Vista ® to configure the router or third party software.
When you first set up the router, Wi-Fi protection is disabled and unconfigured. To enjoy the benefits of Wi-Fi protection, the
router must be both enabled and configured. There are three basic methods to accomplish this: use Windows Vista’s built-in
support for WCN 2.0, use software provided by a third party, or manually configure.
If you are running Windows Vista ® , log into the router and click the Enable checkbox in the Advanced > Wi-Fi Protected Setup
window. Use the Current PIN that is displayed in the PIN Settings section of Advanced > Wi-Fi Protected Setup window or
choose to click the Generate New PIN button or Reset PIN to Default button.
If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are finished, proceed
to the next section to set up the newly-configured router.