D-Link DIR-412 - Manual (Page 49)

45 D-Link DIR-412 User Manual
Section 3 - Configuration
Enter a name for the rule. You may select a pre-defined
application from the drop-down menu and click <<.
This is the port used to trigger the application. It can be either
a single port or a range of ports.
Select the protocol of the trigger port (TCP, UDP, or All).
This is the port number on the Internet side that will be used
to access the application. You may define a single port or a
range of ports. You can use a comma to add multiple ports or
port ranges.
Select the protocol of the firewall port (TCP, UDP, or All).
Select a schedule for when the Application Rule will be enabled.
If you do not see the schedule you need in the list of schedules,
go to the Tools > Schedules screen and create a new schedule.
Name:
Trigger:
Traffic Type:
Firewall:
Traffic Type:
Schedule:
Application Rules
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and others.
These applications have difficulties working through NAT (Network Address Translation). Special Applications makes some of
these applications work with the DIR-412. If you need to run applications that require multiple connections, specify the port
normally associated with an application in the “Trigger Port” field, select the protocol type as TCP or UDP, then enter the firewall
(public) ports associated with the trigger port to open them for inbound traffic.
The DIR-412 provides some predefined applications in the table on the bottom of the web page. Select the application you
want to use and enable it.