D-Link DIR-412 - Manual (Page 54)

50 D-Link DIR-412 User Manual
Section 3 - Configuration
Firewall Rules
Enter a name for the firewall rule.
Use the drop-down menu to specify if the router should Allow or Deny
traffic matching the firewall rule.
Use the drop-down menus to select the Source and Destination
interfaces for the Firewall Rule
Use the IP Address fields next to each Interface drop-down menu to
specify the IP address ranges for the Source/Destination interfaces.
The first host in the IP address range should be entered in the top field
and the last host in the IP address range should be entered in the field
beneath for both the Source/Destination intefaces.
Use the drop-down menu to select the protocol that will be used for
the firewall rule (TCP, UDP, ICMP, or ALL).
Enter the range of ports that the firewall rule will apply to.
The first port in the port range should be entered in the top field and
the last host in the port range should be entered in the field beneath.
Use the drop-down menu to select the schedule for the Network
Filter rule. Click the New Schedule button to bring up the “Schedule
Webpage” to configure the new schedule.
Name:
Action:
Interface:
Protocol:
Port Range:
Schedule:
To create a firewall rule, configure the parameters as described below: