OWON TDS Series - Manual (Page 68)

6.Communication with PC
63
Utility button, select Config in the left menu. Select Net Config in the bottom menu.
Set the IP Address and Port to the same value as the "Ports-settings" in the software
in step (3). The Netmask and Gateway should be set according to the router. You can
refer to "To set the network parameters" on P45. T ouch to complete the
setting. If you can get data normally in the software, the connection is successful.
Figure 6-7 Set the network parameters of the oscilloscope
To learn about how to operate the software, you can press F1 in the software to open the
help document.