OWON TDS Series - Manual (Page 58)

5.Advanced User Guidebook
53
Figure 5-10 Waveform of Voltage Cursor Measurement
Carry out the steps below for the time cursor measurement of the channel CH1:
1. Press the Cursor button.
2. Select Source in the bottom menu; select ① in the left menu.
3. Select Type in the bottom menu; select Time in the right menu. Two red
dotted lines displayed along the vertical direction of the screen, which
indicating L1 and L2.
4. Select Line in the bottom menu; select L1 in the right menu. The icon
will appear beside the dotted line of L1, represents you can turn the G knob
to adjust the position of L1. Select L2 to adjust the position of L2. Select
L1&L2 to adjust the two cursors together. The cursor measure window at the
top right shows the present time of cursor 1 and cursor 2, the absolute
difference and the frequency (see Figure 5-11).