Rear panel – OWON TDS Series User Manual
Page 12
4.Junior User Guidebook
7
Rear Panel
6
5
4
3
2
1
7
Figure 4-2 Rear Panel
1. USB Host port: It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "host device".
For example: upgrading software by USB
flash disk needs to use this port.
2. USB Device port: It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "slave device". For example: to use this port when
connect PC to the oscilloscope by USB.
3. VGA port: To connect the oscilloscope with a monitor or a projector as VGA output.
4. LAN port: the network port which can be used to connect with PC.
5. The port of trigger signal output & Pass/Fail output
6. AC power input jack
7. Handle