OWON TDS Series - Manual (Page 64)

6.Communication with PC
59
6. Communication with PC
TDS series digital storage oscilloscope support communications with a PC through USB
or LAN port. You can use the communication software to store, analyze and display the
data.
Here is how to connect with PC. First, install the communication software on the supplied
CD. Then there are several ways of connection to choose from.
Using USB Port
(1) Connection: Use a USB data cable to connect the USB Device port in the rear panel
of the Oscilloscope to the USB port of a PC.
(2) Install the driver: Run the communication software on PC, press F1 to open the help
document. Follow the steps of title "I. Device connection" in the document to install
the driver.
(3) Port setting of the software: Run the software; click "Communications" in the menu
bar, choose "Ports-Settings", in the setting dialog, choose "Connect using" as "USB".
After connect successfully, the connection information in the bottom right corner of
the software will turn green.
Figure 6-1: Connect with PC through USB port