OWON TDS Series - Manual (Page 50)

5.Advanced User Guidebook
45
How to Implement the Auxiliary System Function Setting
●Config
To change the user interface language
1. Press the Utility button, select Config in the left menu.
2. Select Language in the bottom menu; select the desired language in the right
menu.
To set the network parameters
Using the LAN port, the oscilloscope can be connected with a computer directly, or
through the router to connect. The network parameters can be set in Net Config
dialog. Refer to "Using LAN Port" on P60 for the operation steps.
1. Press the Utility button, select Config in the left menu.
2. Select Net Config in the bottom menu; the IP Config dialog will pop up.
3. Touch the byte to show the cursor, you can drag to select the numbers. Select the
number keys below in the dialog to change the value, the range of each byte is
0～255. The range of Port is 0～65535. Touch to delete current byte.
Touch to complete the setting.
To change the date and time
1. Press the Utility button, select Config in the left menu.
2. Select Time Config in the bottom menu; the Time Setting dialog will pop up.
3. Touch the value that needs to be changed, a cursor will appear. You can drag to
select the numbers. Turn the G knob to change the selected value. Touch OK to
complete the setting.
To enable/disable VGA output
The VGA port could be connected to a computer monitor. The image of the
oscilloscope can be clearly displayed on the monitor.
1. Press the Utility button, select Config in the left menu.
2. Select VGA as ON or OFF in the bottom menu.
●Display
Press the Utility button and select Display in the left menu.
The description of
Display Menu is shown as the follows: