Installation and wiring, Rne modular controller field technical guide, Or greentrol – Orion System RNE Modular Controller User Manual

Page 39

RNE Modular Controller Field Technical Guide

INSTALLATION AND WIRING

Air Flow Monitoring Station Installation and Wiring

Figure 31: OE365-15-EBA - Airfl ow Monitoring Station To E-BUS Wiring

COMM

NET-

NET+

Airflow Measurement

Digital Transmitter Terminals

For Outdoor Air CFM

(Set Address Switch To 9)

Airflow Measurement

Digital Transmitter Terminals

For Return Air CFM

(Set Address Switch To 10)

Airflow Measurement

Digital Transmitter Terminals

For Supply Air CFM

(Set Address Switch To 11)

COMM

NET-

NET+

RNE Controller

OE365-15-EBA

E-BUS Adapter Board

HSSC Cable Connect To

RNE E-BUS Port

I2C DIGITAL

SENSOR

I2C

EXPANSION

STATIC

PRESSURE

ANALOG INPUT JUMPER SETTINGS
MUST BE SET AS SHOWN FOR
PROPER OPERATION

24 VAC POWER ONLY

WARNING! POLARITY MUST BE OBSERVED

OR THE CONTROLLER WILL BE DAMAGED

AI2

AI3

AI4

THERM

4-20mA

0-10V

0-5V

AI5

AI7

WattMaster Label

#LB102033-01

AI1 AI2 SET

AI3 SET

AI4 SET

AI5 SET

AI7 SET

AI2

AI3

AI4

AI5

AI7

EMERGENCY SHUTDOWN

AI1 SET

AI1

THERM

4-20mA
0-10V

0-5V

ANALOG INPU

JUMPER

SETTINGS

Connect To

RNE E-BUS Port

Air Flow Monitoring Station

Installation and Wiring

The OE365-15-EBA E-BUS Adapter Board is used to connect selected
Air Flow Monitoring Stations to the RNE Controller. Currently, there
are two Air Flow Monitoring Station options that are supported in our
standard software.

• EBTRON

- GTC-116 Series Air Flow Monitoring Station*

•

GreenTrol™ Automation – GA-200-N Module used with

any GF Series Air Flow Monitoring Station

The wiring for the two Air Flow Monitoring Stations are the same and
are shown in Figure 31.

*NOTE: When confi guring the GTC-116 Series, be sure to set

the Parity to “NO PARITY, 1 STOP BIT.”

NOTE: Up to 3 EBTRON

or GreenTrol

Airfl ow Measure-

ment Digital Transmitters can be attached to each
Adapter Board.

NOTE: If using multiple E-BUS Sensors or Modules, the

E-BUS Hub (HZ-EBC-248 or MS000248) may be
required.