OpenEye CM-511 Installation Manua - Manual (Page 19)

29243AC 19
Dome Control Protocol Setting
Define the protocol you are going to use based on the devices of your surveillance system. Generally, use one
protocol even if the devices are provided by different manufacturers. Use the switch to set your dome control
protocol and the baud rate. Refer to the table below and turn the arrow to choose a protocol for your speed
dome.
Switch No. Protocol Baud Rate
00 VCL 9600
01 Pelco D 2400
02 Pelco P 4800
04 Chiper 9600
05 Philips 9600
07 OPTIX 3 9600
08 AD422 4800
09 DM P 9600
11 Pelco D 4800
12 Pelco D 9600
13 Pelco P 2400
14 Pelco P 9600
15 JVC 9600
21 Kalatel-485 9600
22 Kalatel-422 4800
Example To set the protocol Pelco D, with switch no. 1 and baud rate 2400,
the protocol switch should be set as at right.
Note
The number 0 should be at the top, as shown, when setting the
camera ID.