OpenEye Gen5 NVR - Manual (Page 85)

30777AC 85
INCLUDED SOFTWARE SETUP
MDVR OVERVIEW
OpenEye MDVR software, available for iPhone, Android, and Blackberry, allows you to access your
OpenEye recorder from almost anywhere on your mobile device. MDVR give you the ability to view live
video from your cameras using a simple interface.
For a list of supported models, installation instructions and download links, go to
http://www.openeye.net/
EMERGENCY AGENT OVERVIEW
The Emergency Agent software is a utility that streams video across a Local Area Network to a Client
PC when an alarm is detected on the recorder. The video that streams across can be stopped, played
forwards and backwards, in slow motion or real speed.
The utility is loaded at startup and placed in the taskbar. It constantly monitors for a signal from the
recorder. When an alarm signal is detected the Emergency Agent Image Viewer window opens and
starts playing the video from the camera associated to the alarm.
Configuring the Recorder
To enable the Emergency Agent on the recorder follow these steps:
1. From the Display screen, click Setup.
2. Click Camera.
3. Select a camera and associate sensors to that camera using Sensor Connection option.
4. Click Network and make sure that Disable Remote Control is cleared.
Note The Emergency Agent uses one port to transfer the data through the network (the Emergency
Port). The port can be adjusted inside the Network menu if necessary. It is recommended that
the default setting should be used unless the port must be changed.
5. Click Schedule.
6. Enter the IP Address of the workstation running the Emergency agent software under Emergency
IP section.
7. Click the box next to the IP Address to enable it.
8. Select the Sensor option and create a schedule for the appropriate sensor (see the Schedule
Setup chapter in this manual for further details).
9. Click Apply, then click Exit Setup.