OpenEye Gen5 NVR - Manual (Page 50)

50
Scheduling Alarm Events
There are three types of Alarm Events:
•
ALARM EVENT: This option logs the Alarm Events on the local server.
•
CENTRAL STATION: This option sends a Map Alarm to Radius.
•
EMERGENCY AGENT: This option sends the Alarm Event to the Emergency Agent software.
Motion can be designated as an alarm event. Often motion does not need to be treated as an Alarm
event. For example: During work hours, motion that occurs is expected and should not be treated as an
alarm. However, after business hours, any motion that occurs could be treated as an alarm.
1. From the Display screen, click Setup.
2. Click Schedule.
3. Select either Recording or Sensor.
4. Highlight time blocks in the schedule that have been set to Motion (or Sensor) and click the desired
Event buttons (Alarm Event, Central Station, Emergency Agent). A corresponding letter will display
in the selected time blocks.
Emergency Agent Schedule
Video recording triggered by motion or sensor events can be sent to the Emergency Agent software.
1. Enable the Emergency Agent Event. (see Scheduling Alarm Events above).
2. Enter the IP Address of a PC running the Emergency Agent software under Emergency IP.
3. Select the check box next to the IP Address to enable it. Only one IP Address is supported at a
time.
4. Enter the recording duration (in seconds) in the Emergency Time box.
Tip See the Emergency Agent chapter for detailed information on setting up the Emergency
Agent software.