NavCom SF-3050 Rev.B - Manual (Page 50)

SF-3050 User Guide – Rev B
baselines, it may take a minute or two.
Features … Applies to All Software Bundles
Output Data Rate
The SF-3050 GNSS receiver can output proprietary
raw data at programmable rates from <1Hz to
predetermined rates up to 100Hz
1
and Position
Velocity Time (PVT) data at programmable rates from
<1Hz to predetermined rates up to 100Hz
1
through the
data ports
2
with less than 10ms latency. Accuracies
are maintained as each output is independently
calculated based on an actual GNSS position
measurement, as opposed to an extrapolation/
interpolation between 1Hz measurements.

The throughput capacity of the ports is
limited by the Baud rate and the byte
size and number of messages output.
NCT Binary Proprietary Data
The sensor can output proprietary raw data
containing information including (but not limited to):

Satellite Ephemeris (EPEM1B)

Satellite Almanac (ALM1B)

Raw Pseudorange Measurements (MEAS1B)

Position, Height, & Time (PVT1B)

Velocity & Heading (PVT1B)

Signal to Noise (CHNLSTATUS1B)

Channel Status (CHNLSTATUS1B)

Correction Data (mirror data; RTKSTATUS1B)
1
Dependent on bundle options .
2
Refer to Chapter 3,
Communications Ports, for details.
2-48