NavCom SF-3050 Rev.B - Manual (Page 119)

SF-3050 User Guide – Rev B
For example:
The default navigation elevation mask is 7
°.
The user changes the elevation mask to 12
° in
a profile named “Test”. The user subsequently
sends profile “RTK” to the receiver. It replaces
“Test”, and changes navigation mode settings
and port assignments.
But profile “RTK” does not specify a setting for
the navigation elevation mask. So, the
elevation mask remains at 12
°, as previously
set by the “Test” profile.

Refer to the Sapphire TRM for detailed
information on the [PROFILE] and
[USEPROFILE] command mnemonics (see
Related Documents in the fore-matter).
Profile NONE
The command, [USEPROFILE] NONE, resets all of
the user-controlled configuration parameters to the
factory default values. The receiver’s profile remains
set to NONE until another profile is successfully input.

The profile NONE is subject to change.
3
rd
Party Controller Configuration Settings
Please refer to the third party controller solution
manual/user guide if your SF-3050 GNSS sensor is
part of an integrated solution.
5-117