NavCom SF-3050 Rev.B - Manual (Page 106)

SF-3050 User Guide – Rev B
Communication Port Connectivity
There is no default control port or data port on the
receiver. COM1 - LAN is the only Ethernet (LAN)
compliant port. COM2 - USB is the only USB
compliant port.
Establish communications via Bluetooth or a data
cable:

Setup Bluetooth communications via either the
supplied StarUtil-3000 utility or a third party
software/utility.

Connect the Positronic 9-Pin connector of the
supplied DB9S cable (P/N 94-310260-3006LF) to
COM1 - LAN (RS-232/1PPS) or COM2 - USB
(RS-232/RS-422) of the SF-3050. Connect the
DB9S end to the control device.

Connect the Positronic 9-Pin connector of the
supplied USB 2.0 Device cable (P/N 94-310266-
3006LF) to COM2 - USB of the SF-3050. Connect
the USB plug end to the control device.

Figure 66 shows a common configuration with
the control device connected to COM1 - LAN
and an auxiliary device connected to
COM2 - USB for data logging.

Some devices may require an additional
adapter. The optional interface data cables
support USB 2.0 Device and Host, Ethernet,
and RS-232 and RS-422 (refer to Table 12).
The receiver is configured as a DCE device.
4-104