Factory default output messages, Table 23: factory default nct messages/responses – NavCom SF-3050 Rev.B User Manual
Page 115
SF-3050 User Guide – Rev B
The user has full control over the utilized message
types and their associated rates via either
StarUtil-3000 or a third party software/utility.
Factory Default Output Messages
NCT
Messages
Table 23: Factory Default NCT Messages/Responses
Output on Ports COM1 and USB1
Message Rate Description
ALM1B
On Change
Satellite Almanac
CHNLSTATUS1B
On Time 1Hz
ASIC & StarFire Channel
Status
EPHEM1B
On Change
Satellite Ephemeris
MEAS1B
On Time 1Hz
Raw Satellite
Measurement Data
MSGPRODUCTINFO
On Time 600 Sec
Product Type, Digital Serial
Number, and System
Revision Number
MSGVERSION
On Time 600 Sec
Firmware Identification
Block
PVT1B
On Time 1Hz
Position, Velocity, and
Time (PVT) Solution
PANICA
On Change
Factory Use
Output on All Ports
Message Rate Description
OK (mnemonic)
On Change
Ack (“Acknowledged”).
Ack indicates a successful
input message operation.
?? (mnemonic)
{argument error}
On Change
Nak (“Not Acknowledged”).
NAK indicates a failure in
executing a command.
PANICA
On Change
Factory Use
5-113