MovinCool CM12 Service Manual - Manual (Page 54)

Repair Section
54
3) Take out the four (4) screws, and then remove
the ring. Loosen the set screw with an Allen
wrench and remove the fan.
CAUTION
When assembling the ring, ensure that the
straight surface of the ring is facing forward.
4) When assembling the fan, ensure that the screws
align with the motor axis positioning holes.
CAUTION
• Tightening torque:
- 10.80 ± 2.17 ft•lbf (14.7 ± 3.0 N•m)
• Verify the clearance between the fan and case
ring. After installing the fan and fan motor,
ensure that the clearance between the fan and
case ring is at least 0.12 in (3 mm).
5) Take out the four (4) screws, and then remove
the fan motor.
CAUTION
When assembling the motor, ensure that the
wire connection ends are facing down.
ILL00543-00
Screws (4)
Ring
Fan
Set Screw
I002780
Motor Axis
Set Screw
0.12 in (3mm)
or more 0.12 in (3mm)
or more
ILL00544-00
Wire Connection
Motor
Bolts (4)