MicroE Mercury II 5000 - Manual (Page 7)

System Overview
IM-Mercury_II_5000_Series Rev. 1 Page 6 ©2014 MicroE Systems
Mercury II 5000 Series Encoders
Installation Manual and Reference Guide
3.3 SmartPrecision Alignment Tool
The Mercury II ATMII5000 SmartPrecision Alignment Tool is required for aligning the Mercury II
5000 Series Encoders. The Alignment Tool includes the following:

Alignment Tool

SmartPrecision II Software

USB Cable

Power Supply
For more details, see Sensor Installation Tools in Appendix 7.0 Order Guide .
Mercury II 5000 Alignment Tool LEDs
LED Function
Power/Cal. Indicates power is on and when
encoder is in Alignment Mode
Red Signal Strength Indicates improper alignment
Yellow Signal Strength Indicates improved alignment
Green Signal Strength Indicates proper alignment
Left Limit Blinks in Alignment Mode and when
sensor is located over left limit
Right Limit Blinks in Alignment Mode and when
sensor is located over right limit

15 Pin D-Sub
Sensor Connector
Left Limit LED
Cal. Pushbutton
(Recessed)
Ethernet Connector
Alignment Tool
Adapter
Right Limit LED
Power Supply
Connect