Microcom 814M Operators Manual - Manual (Page 44)

40
Appendix
Self-test Page
Print self-test page in the following steps:
• Turn off the printer power.
• Hold the feed button for at least one second while turning on the power.
The printer will start to print a self-test page. Take the 203 dpi, Serial + USB interface model as an example.
The self-test paper is shown as follows:
***MICROCOM814M-3 TEST FORM***
Boot
Firmware :FV2.010
Main Firmware :FV2.050
H/W
Parameters
H/W ID :MICROCOM814-3(U) 1
Flash Memory Size :1M bytes
Flash Logos Size :64k bytes
Resolution :300×300DPI
Print Width (Max) :216mm
Fixed Left Margin :2mm
Fixed Right Margin :2mm
Print Speed (MAX) :75mm/s
Dark Scale :100
Cutter :Enabled
Paper Roll Width :216mm
Presenter :Enabled
Presenter Mode :Keep Paper
Presenter Wait Time :3s
Communication
Interface
Rx Buffer Size :4K bytes
Interface Type1 :RS232
Baud Rate :38400bps
Data Bits :8
Stop Bits 1
Parity :NONE
Flow Control :DTR/DSR
Command CR :Disabled
Data Receive Error :Ignored
Interface Type2 :USB_ORU
Resident Fonts
Font0 (18x34) :English
Font1 (13x24) :English
Code Pages :437,850,852
:858,860,863