Microcom 814M Operators Manual - Manual (Page 20)

16
4 Installation
4.1 Unpacking
Open the carton and all packing materials, and verify that all items on the packing list are enclosed. In case of
damaged or missing items, please contact your dealer or the manufacturer for assistance.
4.2 Assembling the Printer
For safety purpose, the print mechanism and paper holder should be packed separately in transport. Before
placing the printer into use, assemble the print mechanism and paper holder according to the following figures.
Note:
Make sure to plug paper near-end sensor into its connector (see figures 3-12 and 3-13).
4.3 Connecting the Grounding Wire
To ensure that the printer has a good ground, please see figure below to connect the ground wire correctly.
Figure 4-1 Vertical Type
Figure 4-3 Connecting the Ground Wire
Figure 4-2 Horizontal Type
Paper near-end
connector