Microcom 814M Operators Manual - Manual (Page 4)

iv
Safety Instructions
Before installing and using the printer, please read the following items carefully:
• Install the printer on a flat and stable place.
• Reserve adequate space around the printer so that the operation and maintenance
can be performed conveniently.
• Do not use or store the printer in direct sunlight, strong heat, high humidity or dew
condensation.
• Do not place the printer in a place exposed to vibration or impact.
• Connect the DC adapter to an appropriately grounded outlet. Avoid sharing one
electrical outlet with large power motors and other devices that may cause the
fluctuation of voltage.
• Take care not to spill liquids into the printer. In case this happens, turn off the power
immediately.
• Do not allow the printer to start printing when there is no paper installed, otherwise
the print head and platen roller may be damaged.
• Use only recommended paper.
• Shut down the printer when connecting or disconnecting the interface connectors to
avoid damage to control board.
• Use the lowest print darkness setting possible to produce acceptable print quality to
prolong printhead life.
• Disassembly of the printer should only be done by properly trained technicians.
• Keep this manual available for reference.