Microcom 814M Operators Manual - Manual (Page 22)

18
Notes:
− When connecting the serial interface cable, do not forget to tighten the retaining screws. For parallel
interface cable, make sure to close the clips.
− When connecting or disconnecting the interface cable, make sure to hold the plug shell instead of the
the cable only.
4.6 Loading Paper Roll
Before loading paper, confirm that the paper specifications match the printer’s requirements (see table 2.2
Paper Specification)
4.6.1 Loading Process
1. Before loading the paper roll, verify that the paper width is 210mm to 216mm and determine if the
paper roll-spacer blocks are required.
If the paper roll is 210mm wide, a paper roll-spacer block is needed
If the paper roll is 216mm wide, a paper roll-spacer block is not needed.
Figure 4-6 Connecting the USB Interface Cable Figure 4-7 Connecting the Parallel Interface Cable
Paper roll-spacer blocks
Position retaining flat spring