Microcom 814M Operators Manual - Manual (Page 21)

17
4.4 Connecting the AC Power Adapter
1. Make sure the printer is turned off.
2. With the flat side of the cable pin of AC adapter facing downward, plug the cable pin into the power
interface on the side of the printer.
3. Connect the AC power cable to a nearby electrical outlet.
4.5 Connecting the Interface Cable
1. Make sure the printer has been shut down.
2. Connect the interface cable into relevant connector of the printer and secure with applicable screws or
latch springs (see figures 3-14 and 3-15).
3. Connect the other end of the interface cable to the host.
Figure 4-4 Connecting the AC Adapter
Figure 4-5 Connecting the Serial Interface Cable