Measurement Computing CIO-DAS16Jr/16 - Manual (Page 6)

1.5 INSTALLING THE BOARD
Having configured the board’s switches and jumpers, it is now time to install the board into an ISA slot in the PC.
1. Turn the power off.
2. Remove the cover of your computer. Please be careful not to dislodge any of the cables installed on the boards in your
computer as you slide the cover off.
3. Locate an empty ISA expansion slot in your computer.
4. Push the board firmly down into the expansion bus connector. If it is not seated fully it may fail to work and could
short circuit the PC bus power onto a PC bus signal. This could damage the motherboard or the circuit board.
5. Turn the PC power back on and verify proper installation by running InstaCal Test (refer to the Software Installation
Manual for information on running InstaCal.
2