Measurement Computing eZ-Balance rev.9.0 - Manual (Page 12)

2-6 A Balancing Project 987091 eZ-Balance
Input Channels Tab
Use this panel to configure each channel for your balance job. Select a channel then set the values for each
attribute. Repeat for each channel.
Balance Configuration, Input Channels Tab
4. Perform Balancing Operations
Balance Data can be acquired with the acquisition device on-line, or it can be entered manually (off-line).
Use the Balance Operations flowchart to sequentially select the balance project’s steps. The number of
Balance Steps depends on the number of Balance Planes. There will be a Trial Run for every Balance
Plane.
Balance Operations Flowchart
Selecting (0) Initial Balance Run
The number of balance steps depends on the number of balance planes. There will be a
trial run for every balance plane.