Measurement Computing WaveView - Manual (Page 35)

WaveView 03-05-02 WaveView, pg. 33
Analog Meters
You can use the Analog Meters button or select Analog Meters from WaveView’s View pull-down menu to
access the Analog Meters window. This window displays several channels in a dial/gage format. To
activate the display, select the Start button (A) from the toolbar. You can select to view up to 32 meters at a
given time.
Note: To view an active meter, at least one active (On) channel must be assigned to the meter, and the
Reading’s column (on WaveView’s main window) must be enabled.
Analog Meters, Shown with 4 Meters Selected for Viewing
Double-clicking the left mouse button in a meters scale area brings up a channel selection pop-up menu (not
shown). A single-click with the right mouse button in this same area brings up a configuration pop-up menu
(see Bar Graph Meters figure, item H). Both of these pop-up menus are discussed in the section, Meters
Configuration Menu.
The items in this window are as follows:
A- Start C - Reset Peak Hold E - Print G - Number of Meters
B- Stop D - Stay On Top F - Rows x Columns
These items are discussed in more detail, following the description of the Digital Meters.
Configuration Note: …. for Analog Meters
For Analog Meters, configure the meter settings by first clicking the right mouse button anywhere
within the meter display area. A pop-up menu will appear allowing you to reconfigure the meter in
regard to scale, limits, channel selection, adding peak hold indicators, etc. Refer to the section
entitled
Meters Configuration Menu for more detail.