beautypg.com

8 selected device clear, 9 serial poll disable, 10 serial poll enable – Measurement Computing Serial488/4 User Manual

Page 80: 11 group execute trigger, 12 take control, 13 secondary command group

background image

Section 4

IEEE 488 Primer

4.9

4.7.8 Selected Device Clear (SDC)

This causes a single device to be initialized to a pre-defined or power up

state. ($04)

4.7.9 Serial Poll Disable (SPD)

The SPD command disables all devices from sending their Serial Poll

status byte. ($19)

4.7.10 Serial Poll Enable (SPE)

A device which is A ddressed to T alk will output its Serial Poll status

byte after SPE is sent and ATN is unasserted. ($18)

4.7.11 Group Execute Trigger (GET)

This command usually signals a group of devices to begin executing a

triggered action. T his allows actions of

different devices to begin

simultaneously. ($08)

4.7.12 Take Control (TCT)

This command passes bus control responsibilities from the current

Controller to another device which has the ability to control. ($09)

4.7.13 Secondary Command Group (SCG)

These are any one of the 32 possible commands (0 to 31) in this group.

They must immediately follow a talk or listen address. ($60 to $7F)

This manual is related to the following products: