Measurement Computing Serial488/4 - Manual (Page 12)

Section 1 Introduction
Fuse:
1/4A Slo Blo (for 105-125V power line) or 1/8A Slo Blo (for 210-250V power
line)
&$87,21
Fuse Failure: Fuse failure indicates a possible problem within the
device circuitry. If a fuse blows, contact a qualified service
representative. Replacement fuses are to be installed by qualified
service personnel with the unit disconnected from the power
source and with all other terminals disconnected. If the line
voltage selector is changed, the fuse designated for use with that
line voltage must be used.
1.4 Abbreviations
The following IEEE 488 abbreviations are used throughout this manual.
addr n IEEE bus address "n" PPC Parallel Poll Configure
ATN Attention line PPU Parallel Poll Unconfigure
CA Controller Active SC System Controller
CR Carriage Return SDC Selected Device Clear
data Data String SPD Serial Poll Disable
DCL Device Clear SPE Serial Poll Enable
GET Group Execute Trigger SRQ Service Request
GTL Go To Local TA Talker Active
LA Listener Active TAD Talker Address
LAG Listen Address Group TCT Take Control
LF Line Feed term Terminator
LLO Local Lock Out UNL Unlisten
MLA My Listen Address UNT Untalk
MTA My Talk Address * Unasserted
1.4